Keysight Technologies P Series Programming Manual page 282

7 MEMory Subsystem
MEMory Subsystem
The MEMory command subsystem is used to:
– Edit and review sensor calibration tables (8480 Series
– Store sensor calibration tables (8480 Series sensors only)
– Edit and review sensor frequency dependent offset tables
– Store sensor frequency dependent offset tables
– Edit and review sensor save/recall registers
Stored tables remain in the power meter's memory during power down. The
power meter is capable of storing 20 sensor calibration tables and 10 frequency
dependent offset tables of 80 frequency points each.
The MEMory subsystem is not used for E-Series and P-Series power sensors
NOTE
calibration tables. These are automatically downloaded to the power meter and
cannot be reviewed or edited.
Keyword
MEMory
:CATalog
[:ALL]?
:STATe?
:TABLe?
:CLEar
[:NAME]
:TABLe
:FREE
[:ALL]?
:STATe?
282
sensors only)
Parameter Form
<character_data>
Keysight N8262A Programming Guide
Notes Page
[query only] page 285
[query only] page 287
[query only] page 288
[no query], page 292
[non-SCPI]
[no query] page 294
[query only] page 296
[query only] page 297