Keysight Technologies P Series Programming Manual page 80

1 Power Meter Remote Operation
The legal frequency suffix multipliers are any of the IEEE suffix multipliers, for
NOTE
example, KHZ, MHZ, and GHZ. If no units are specified the power meter assumes
the data is Hz.
PCT is the only legal unit for offset factors and can be omitted.
The frequency and offset data must be within range. Refer to the individual
commands in
Any offset values entered into the table should exclude the effect of the sensor.
Characterization of the test setup independently of the sensor allows the same
table to be used with any sensor.
Ensure that the frequency points you use cover the frequency range of the
signals you want to measure. If you measure a signal with a frequency outside
the frequency range defined in the frequency dependent offset table, then the
power meter uses the highest or lowest frequency point in the table to calculate
the offset.
To make subsequent editing of a frequency dependent offset table simpler, it is
recommended that you retain a copy of your data in a program.
Listing the Frequency Dependent Offset Table Names
To list the frequency dependent offset tables currently stored in the power meter,
use the following command:
MEMory:CATalog:TABLe?
Note that all tables are listed; including sensor calibration tables.
The power meter returns the data in the form of two numeric parameters and a
string list representing all stored tables.
– <numeric_value>,<numeric_value>{,<string>}
Each string parameter returned indicates the name, type and size of a stored
frequency dependent offset table:
80
Chapter 4
The first numeric parameter indicates the amount of memory, in bytes, used
for storage of tables. The second parameter indicates the memory, in bytes,
available for tables.
for their specified ranges.
Keysight N8262A Programming Guide