Syntax - Keysight Technologies P Series Programming Manual

TRACe[1]|2:MEASurement:TRANsition[1]|...|10:POSitive:OCCurrence?
This command returns the position, relative to the trigger instant, of the n
occurrence of a positive transition found on a trace.

Syntax

TRAC
Reset Condition
On reset, this parameter is not affected.
Example
Error Messages
– If a P-Series sensor is not connected, error –241, "Hardware missing" occurs.
– If a P-Series sensor is connected and Free Run trigger acquisition is selected,
TIf you attempt to measure a pulse out of the range of the capture, for example,
NOTE
measure the 5th pulse and there are only 4 pulses displayed, the power meter
returns #0#0#0 as the result.
Keysight N8262A Programming Guide
:MEAS
1
2
TRAC2:MEAS:TRAN:POS:OCC?
error –221, "Settings conflict" occurs.
:TRAN
1
2|...|10
This command returns the position, relative
to the trigger instant, of the 1st occurrence
of a positive transition found on trace 2.
TRACe Subsystem
:POS :OCC
13
th
?
557