Example - Keysight Technologies P Series Programming Manual

Modular power meter

Hide thumbs Also See for P Series:

Table of Contents

SENSe Subsystem

Example

CORR:CSET1 'PW1'

Reset Condition

On reset the selected table is not affected.

[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:[SELect]?

The name of the selected table is returned as a quoted string. If no table is

selected an empty string is returned.

Query Example

Error Messages

– If <string> is not valid, error –224, "Illegal parameter value" occurs.

– If a table called <string> does not exist, error –256, "File name not found"

– When a sensor calibration table is selected, the power meter verifies that the

– If the CSET1 command is used when a P-Series or an E-Series Power Sensor is

number of calibration points defined is one more than the number of frequency

points defined. When a frequency dependent offset table is selected, the

power meter verifies that the number of offset points defined is equal to the

number of frequency points defined. If this is not the case, error –226, "Lists

not the same length" occurs.

connected the error –241, "Hardware missing" occurs.

This command enters the name of the sensor

calibration table which is to be used on

This command queries the sensor calibration

table currently used for Channel A.

Keysight N8262A Programming Guide

Table of Contents