Calculate[1]|2|3|4:Gain Commands - Keysight Technologies P Series Programming Manual

Modular power meter

Hide thumbs Also See for P Series:

Table of Contents

CALCulate Subsystem

CALCulate[1]|2|3|4:GAIN Commands

These commands are used to enter and enable a display offset on the specified

window/measurement. The display offset is applied to the measurement signal

after any math calculation.

The following commands are detailed in this section:

CALCulate[1]|2|3|4:GAIN[:MAGNitude] <numeric value>

CALCulate[1]|2|3|4:GAIN:STATe <boolean>

Keysight N8262A Programming Guide

Table of Contents