List Of Monitor Displays - YASKAWA JUSP-MD D01A Series User Manual

10 Appendix

10.3 List of Monitor Displays

The following list shows the available monitor displays.
Parameter
No.
Un000
Un001
Un002
Un003
Un004
Un005
Un006
Un007
Un008
Un009
Un00A
Un00B
Un00C
Un00D
Un012
Un013
Un014
Un015
Un020
Un021
∗1. For details, refer to 8.4 Monitoring Input Signals.
∗2. For details, refer to 8.5 Monitoring Output Signals.
∗3. For details, refer to 8.3 Reading 32-bit Data in Decimal Displays.
∗4. For details, refer to 5.4.4 Electronic Gear.
∗5. If the reference pulse input multiplication switching function is enabled, the reference pulse will be multiplied by n to
obtain the reference.
10-34
Motor rotating speed
Speed reference
Internal torque reference (percentage of the rated torque)
Rotational angle 1 (encoder pulses from the phase-C origin:
*3
decimal display)
Rotational angle 2 (from polarity origin (electric angle))
*1
Input signal monitor
*2
Output signal monitor
*6
Input reference pulse speed (valid only in position control)
*6
Position error amount (valid only in position control)
Accumulated load ratio (in percentage to the rated torque:
effective torque in cycle of 10 seconds)
Regenerative load ratio (as a percentage of the processable
regenerative power: regenerative power consumption in cycle
of 10 seconds)
Power consumed by DB resistance
(in percentage to the processable power at DB activation: dis-
played in cycle of 10 seconds)
*3,*5
Input reference pulse counter
*3
Feedback pulse counter
Total operation time
*3
Feedback pulse counter
Effective gain monitor (gain settings 1 = 1, gain settings 2 = 2) −
Safety I/O signal monitor
Motor rated speed
Motor maximum speed
Description Unit
-1
min
-1
min
%
∗4
encoder pulse
deg
−
−
-1
min
reference unit
%
%
%
reference unit
∗4
encoder pulse
100 ms
reference unit
−
-1
min
-1
min