YASKAWA JUSP-MD D01A Series User Manual page 347

10 Appendix
10.2.2 Parameters
Parameter
Size
No.
2 Input Signal Selection 4
4th 3rd 2nd 1st
digit digit digit digit
n.    
Pn50D
2 Output Signal Selection 1
4th 3rd 2nd 1st
digit digit digit digit
n.    
Pn50E
10-28
Setting
Name
Range
0000 to FFFF
/ZCLAMP Signal Mapping (Zero clamp when ON (closed))
0 Active when CN1-40 input signal is ON (closed).
1 Active when CN1-41 input signal is ON (closed).
2
Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5 Active when CN1-45 input signal is ON (closed).
6
Active when CN1-46 input signal is ON (closed).
7 Always active (fixed).
8 Not active (fixed).
9 Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B
Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F
Active when CN1-46 input signal is OFF (open).
/INHIBIT Signal Mapping (Reference pulse inhibit when ON (closed))
0 to F
Same as /ZCLAMP Signal Mapping.
/G-SEL Signal Mapping (Gain change when ON (closed))
0 to F
Same as /ZCLAMP Signal Mapping.
Reserved (Do not change.)
0000 to 3333
Positioning Completion Signal Mapping (/COIN)
0 Disabled (the above signal is not used.)
1 Outputs the signal from CN1-25, -26 output terminal.
2 Outputs the signal from CN1-27, -28 output terminal.
3 Outputs the signal from CN1-29, -30 output terminal.
Speed Coincidence Detection Signal Mapping (/V-CMP)
0 to 3
Same as /COIN Signal Mapping.
Servomotor Rotation Detection Signal Mapping (/TGON)
0 to 3
Same as /COIN Signal Mapping.
Servo Ready Signal Mapping (/S-RDY)
0 to 3
Same as /COIN Signal Mapping.
Factory
Units When Enabled
Setting
−
8888 After restart
−
3211 After restart
(cont'd)
Classifi- Reference
cation Section
−
Setup
Reference
Section
5.3.5
Reference
Section
5.4.8
Reference
Section
6.7.6
−
Setup
Reference
Section
5.4.6
Reference
Section
5.3.8
Reference
Section
5.10.3
Reference
Section
5.10.4