YASKAWA JUSP-MD D01A Series User Manual page 346

Parameter
Size
No.
2 Input Signal Selection 3
4th 3rd 2nd 1st
digit digit digit digit
n.    
Pn50C
Setting
Name
Range
0000 to FFFF
/SPD-D Signal Mapping
(Refer to 5.6 Internal Set Speed Control.)
0 Active when CN1-40 input signal is ON (closed).
1 Active when CN1-41 input signal is ON (closed).
2 Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5
Active when CN1-45 input signal is ON (closed).
6 Active when CN1-46 input signal is ON (closed).
7
Reserved (Do not use.)
8
Not active (fixed).
9
Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F Active when CN1-46 input signal is OFF (open).
/SPD-A Signal Mapping
(Refer to 5.6 Internal Set Speed Control.)
0 to F
Same as /SPD-D Signal Mapping.
/SPD-B Signal Mapping
(Refer to 5.6 Internal Set Speed Control.)
0 to F
Same as /SPD-D Signal Mapping.
/C-SEL Signal Mapping (Control method change when ON (closed))
0 to F
Same as /SPD-D Signal Mapping.
Factory
Units When Enabled
Setting
−
8888 After restart
10.2 List of Parameters
(cont'd)
Classifi- Reference
cation Section
−
Setup
Reference
Section
5.6.1
Reference
Section
5.6.1
Reference
Section
5.6.1
Reference
Section
5.7.1
10
10-27