Monitoring Output Signals; Displaying Output Signal Status; Interpreting Output Signal Display Status - YASKAWA JUSP-MD D01A Series User Manual

8.5

Monitoring Output Signals

The status of output signals can be checked with the output signal monitor (Un006). The procedure for dis-
playing the status, the method of interpreting the display, and a display example are shown below.

8.5.1 Displaying Output Signal Status

Use the following steps to display the output signal status.
Display after
Step
Operation
1
2
3
Output signal display
4

8.5.2 Interpreting Output Signal Display Status

The status of allocated signals is displayed on the 7-segment display on the panel operator.
Output terminals correspond to LED numbers as shown in the following table.
8 7 6 5 4 3 2 1
• When the output signal is in OFF status, the top segment (LED) is lit.
• When the output signal is in ON status, the bottom segment (LED) is lit.
Display LED
Number
1
2
3
4
5
6
7
8
Note: Output signals use the following circuit configuration.
• OFF: Transistor OFF
• ON: Transistor ON
Example
ON: Transistor ON
Keys
MODE/SET
MODE/SET
MODE/SET
status
MODE/SET
Analog
Top: OFF
Bottom: ON
Number
Output Terminal Name
CN1-31, -32
CN1-25, -26
-
CN1-27, 28
CN1-29, -30
CN1-37
CN1-38
CN1-39
−
Press the MODE/SET Key to select the monitor display.
DATA/
Press the UP or DOWN Key to select Un006.
DATA/
The present status can be displayed on the 7-segment dis-
play on the panel operator by pressing the DATA/SHIFT
Key for approximately one second. Refer to 8.5.2 Interpret-
DATA/
ing Output Signal Display Status.
Press the DATA/SHIFT Key for approximately one second
to return to the display of step 2.
DATA/
Signal Name
(Factory Setting)
ALM
/COIN or /V-CMP
/TGON
/S-RDY
ALO1
ALO2
ALO3
Reserved

8.5 Monitoring Output Signals

Operation
8
8-7