YASKAWA JUSP-MD D01A Series User Manual page 44

 Parameters with Setting Ranges of Six Digits or More
Panel operator displays five digits. When the parameter number is more than six digits, values are displayed
and set as shown below.
Top two digits
The example below shows how to set the positioning completed width (Pn522) to "0123456789."
Display after
Step
Operation
1
Before changing
bottom four digits
2
After changing
bottom four digits
Before changing
middle four digits
3
After changing
middle four digits
Before changing
top two digits
4
After changing
top two digits
Leftmost flash display shows digit's
position. The digit's display and value
means parameter's value.
Middle
four
digits
Displays when negative
number is displayed.
Keys
Press the MODE/SET Key to select the parameter setting.
If Pn522 is not displayed, press the DATA/SHIFT Key, the
UP Key, or the DOWN Key to select Pn522.
MODE/SET DATA/
Press the DATA/SHIFT Key for approximately one sec-
ond. The current data for bottom four digits of Pn522 are
displayed. (In this case, "0007" is displayed.)
Press the DATA/SHIFT Key to move to other digits, and
MODE/SET DATA/ change the value by pressing the UP/DOWN Key. (In this
case, "6789" is set.)
Press the DATA/SHIFT Key. The middle four digits will be
displayed. (In this case, "0000" is displayed.)
Press the DATA/SHIFT Key to move to other digits, and
change the value by pressing the UP/DOWN Key. (In this
MODE/SET DATA/
case, "2345" is set.)
Press the DATA/SHIFT Key. The top two digits will be
displayed. (In this case, "00" is displayed.)
Press the DATA/SHIFT Key to move to other digit, and
change the value by pressing the UP/DOWN Key. (In this
case, "01" is set.)
MODE/SET DATA/
The value "0123456789" is set.
2.3 Parameters (Pn)
Analog
Bottom
four digits
Operation
2
2-7