Precor AMT Series Service Manual page 69

USB Test
Touchscreen
Test
Touchscreen
Calibration
Backlight Test
RGB Test
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
1 Touch USB Test.
2 The USB Test will show the number of USB
ports currently active, there should be
six. Insert a USB Flash drive into the
USB port and then Touch CLOSE, and then
All
Touch USB Test again. The number of
active USB ports should be increased by
one.
3 Touch CLOSE to exit to
1 Touchscreen Test.
2 Place your finger on one corner of the
screen and run it around the edges
multiple times.
3 The line drawn by your finger should be
All
very close to previous passes. Be sure
that you do not touch anything else with
your other hand.
4 Touch FINISH to exit to Systems Test.
1 Touch Touchscreen Calibration.
2 A + will be displayed on a white screen.
Touch the +, the spot you just touched
will disappear and then be replaced with
another + in a different location on the
white screen.
All
3 Continue to touch the + as they appear
on the screen until the test
automatically exits to the Systems Test
screen. You cannot exit this test until
all the + have been touched and the
screen is calibrated.
1 Touch Backlight Test
2 The backlight will display three levels
of brightness, 100%, 60%, and 0% in
All
succession in 1 second intervals,
returning to the System Tests menu when
complete.
1 Touch RGB Test.
2 The full screen should move through a
succession of five colors, requiring a
All touch anywhere on the screen to advance
to the next.
Blue, Black, White, returning to the
Systems Tests menu when all the
Systems Test.
These are Red, Green,
Page 67