Figure 311: Tie Rods - Precor AMT Series Service Manual

Figure 311: Tie Rods

Stride Dial Assembly Installation
11 Secure the
do not fully tighten the screws.
12 Adjust the stride dial bracket unit the stride dial target is
centered between the two stride sensors on the stride dial PCA.
13 Fully tight in the two
the frame.
14 Reconnect the stride dial cable connector to the stride dial sensor,
ensure the cable is routed and secured away from the H-Brake cam
stops.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
stride dial assembly to the frame with the two
screws that secure the stride dial sensor to
screws,
Page 354