Machine Controls Incorrect Response; Description; Possible Causes; Possible Remedies - Precor AMT Series Service Manual

3 Check yellow/black cable in console for damage.
inserted fully onto the pins.
cable is damaged, console must be replaced; this is not a
replaceable part.
4 If machine controls have failed, the entire console will need to be
replaced.

Machine Controls Incorrect Response

Description

Machine controls do not respond properly to input – speed up makes
speed go down, incline up makes incline go down, etc.

Possible Causes

1 Bounce-back
of force, the control could rebound with enough force to cause it to
bounce in the other direction, causing the machine to think the user
is actually pressing it in that direction.
2 Cable from machine controls to upper board is damaged or not
inserted properly.
3 Machine controls have failed

Possible Remedies

1 Verify the user is not using excessive force on the controls.
to make sure they are operating properly when appropriate force is
used. Educate customer on proper use of equipment.
2
Test controls in Systems Tests.
Check yellow/black cable in console for damage.
inserted fully onto the pins.
cable is damaged, console must be replaced; this is not a
replaceable part.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
This is not a replaceable part.
If the user if flipping the machine controls with a lot
If not inserted properly, insert.
SeeP80 System Tests
If not inserted properly, insert.
Ensure the cable is
Test
(on page 63).
Ensure the cable is
If
If
Page 121