Replacing The Crank Arm; Crank Arm Replacement Procedure; Figure 229: Generator - Precor AMT Series Service Manual

20 Lift the stairarms and then thread the flat belts over the flat belt
pulleys.
21 Select the QUICKSTART program
resistance level 10 is displayed. Pedal the AMT for approximately
one minute, then recheck the belt tension.

Figure 229: Generator

22 The drive input belt tension should read approximately 135 ±5 lbs
and the generator belt tension should read approximately 85 ±5 lbs.
Drive Belt Gauge Instructions
See
23 Lift the stairarms and thread the flat belts through the pulleys.
24 Replace the covers as per procedure,

Replacing the Crank Arm

Crank Arm Replacement Procedure

1 Remove covers as per procedure,
2 Remove the tension from the inner flat belt pulleys by lifting up on
the stairarms, pulling the flat belts off the flat belt pulleys, and
then gently setting the stairarm down.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
and adjust the resistance  key until
(on page 142)
Cover Replacement
Cover Replacement
(on page 152).
(on page 152).
Page 291