Precor AMT Series Service Manual page 110

11 Connect the machine to a known good A/V drop.
appears on the console, verify the drop is good.
customer contact their A/V service technician to repair the drop.
Getting a signal strength reading can assist in diagnosing the video
problem.
12 Verify on other machines that this is a valid channel.
would appear as total snow or static (as on a channel that is has no
signal), then the console will display this as a black screen for
that channel.
that it is not a valid channel.
changed or something may be wrong with their head end.
13 If the lineup has changed, rescan to pick up the correct channel
lineup. If other units in the facility also have the incorrect
lineup, you will need to export this new scan information to the
other units.
14 Inspect the black USB cable running from the left side of the tuner
to the USB jacks on the right side of the console.
must be plugged into the correct jack.
the outermost jack (the one closest to you when looking at the back
of the console) plug it into the correct jack.
15 If the signal to the console is good and the TV screen has been
black for more than 5-10 minutes, then the watchdog is not able to
recover the media player.
watchdog may still be trying to automatically recover the system.
16 This can be verified by looking in the Event Log.
indicate a media reboot include: Rebooting the media , The mediaapp
restart is near, i2c timeout, or The OMAP board was rebooted because
the mpaqtapp was not running, though this is not inclusive of all
possible messages.
17 Rebooting the machine will force the media player to reboot.
TV channel appears after rebooting, the issue was the media player.
Verify all channels and operation of unit.
black, then verify all other components are operational.
18 Some older versions of software can experience a bug where only one
component reverts back to a different image.
a much older version of software, this could cause some
communications problems between the CPA and the MFE.
Settings menu and select Reflashing.
the CPA Reflashing and the MFE Reflashing menus to make sure they
are the correct version numbers.
then this bug may have occurred.
it resolves the issue.
to boot that component to the other boot image.
image contains the correct software versions.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
If no machines receive this channel, it is likely
If it is less than 5 minutes or so, the
If not, use the appropriate Reflashing menu
If the TV channel now
The club's channel lineup may have
If it is not plugged into
If the channel is still
If the old image is of
Check the version numbers in
If they are not or say <UNKNOWN>,
Try rebooting the unit to see if
If not, have the
If a channel
The tuner cable
Messages that
If the
Open the
Verify that the new
Page 108