Figure 219: Generator
17 Replace the lower PCA and battery bracket and connect the cables as
per procedure,
18 Replace the lower PCA cover as per procedure,
"Removing the Lower PCA
19 Replace the covers as per procedure,
152).
Replacing the Drive Input Pulley Belt
Drive Input Pulley Belt Replacement Procedure
1 Remove the covers as per procedure,
2 Remove the tension from the inner flat belt pulleys by lifting up on
the stairarms, pulling the flat belts off the flat belt pulleys, and
then gently setting down the stairarm.
3 Place a belt gauge on the drive input belt as shown below.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Replacing the Lower PCA and Battery Bracket
Cover" on page 268).
Lower PCA Cover
Cover Replacement
Cover Replacement
(on page 270).
(see
(on page
(on page 152).
Page 281