Replacing A Tie Rod; Procedure; Figure 299: Gas Shock - Precor AMT Series Service Manual

Figure 299: Gas Shock

Caution: It is recommended to have assistance available for following
step(s).
53
With the assistance, lift the front of the Incline platform until
the Incline tube mounting holes align with the Incline platform
mounting holes.
54 Replace the Incline motor mounting pin through the Incline tube and
Incline platform and attach the hitch pin.
55 Secure the flat belt clamps the lift arm housing using the four 3/8-
16 X 3 mounting bolts and washers.
56 Lift the stairarms and thread the flat belts through the pulleys.
57 Replace the covers as per procedure,

Replacing a Tie Rod

Procedure

1 Remove the covers as described per procedure,
page 152).
2 Remove the tie rod mounting bolt and washer that secures the lower
tie rod end to the cam assembly.
3 Remove the tie rod mounting bolt and washer that secures the upper
tie rod end to the upper arm axle.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Cover Replacement
Cover Replacement
(on page 152).
(on
Page 345