Inspection And Adjustment Procedures; Measuring The Resistance Of A Generator; Procedure - Precor AMT Series Service Manual

Inspection and Adjustment
Procedures
In This Section
Measuring the Resistance of a Generator ............ 127
Inspecting and Adjusting the H-brake Belt Tension .. 129
Inspecting and Adjusting the Generator Belt Tension 130
Inspecting and Adjusting the Drive Input Belt Tension
Calibrating the Incline Motor ...................... 137
Drive Belt Gauge Instructions ...................... 142

Measuring the Resistance of a Generator

Caution: If an external power supply is connected to the AMT,
disconnect the external power supply from the AMT before continuing
with this procedure.

Procedure

1 Remove the right side cover as per Procedure,
page 152).
2 Remove the positive battery wire from the lower PCA.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
S e c t i o n E i g h t
Cover Replacement
132
(on
Page 127