Top Cover Assembly; Replacing A Belt Guard; Finger Guard Replacement Procedure; Figure 82: Upper Arm Covers - Precor AMT Series Service Manual

Top Cover Assembly

Important: In the following steps, do not apply excessive force to seat
the cover.
1 Position the rear edge of the top cover so that the clips on the top
and back covers are engaged securely.
2 Gently snap the front edge of the top cover into place, using the
heel of your hand if necessary.
3 Wrap the gasket around the center fame column below the heart rate
sensor grips, then fit it into the top cover. Make sure that the
surfaces and edges of the gasket are flush with those on the top
cover.

Replacing a Belt Guard

Finger Guard Replacement Procedure

Upper Arm Cover Removal

Figure 82: Upper Arm Covers

1 Remove the four screws that fasten the inside upper arm covers to
the upper arm.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 164