Figure 314: H-Brake Belt Assembly - Precor AMT Series Service Manual

H-Brake Belt Removal
2 Remove the

Figure 314: H-Brake Belt Assembly

3 Slide the right side belt clamp off the cam towards the right,
thread the clamp under the cam and out to the left side of the AMT.
4 Slide the left side belt clamp off the cam towards the right and
remove.
Gas Shock Removal
5 Release tension from the top of the gas shock by pushing a # 1 flat
top screw driver in the slot
completely remove the retaining clip as it is difficult to
reinstall.
Tip: If the incline motor is jammed at full elevation, remove the lower retaining
clip to facilitate the gas shock removal.
6 Using another flat head screw driver as a pry bar, place the screw
driver head between the frame and the top of the gas shock and pry
the shock off the upper mounting stud.
7 Rotate the gas shock down and out of the way of the incline motor.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
H-Brake tension bolt, the two washers and nut.
under the tension clip. Do not
Page 357