Figure 98: Stairarm Height Measurement; Figure 99: Flat Belt Terminal Adjustment - Precor AMT Series Service Manual

Figure 98: Stairarm Height Measurement

15 If the measurement is too low or too high, tighten or loosen the
adjustment bolt until the 3 7/8 inch measurement is achieved.

Figure 99: Flat Belt Terminal Adjustment

16 Repeat the process for the remaining stairarm.
17 Fully tighten the stop bolt, torque to 300 inch pounds (25 ft-lbs)
or 25 foot pounds.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 178