Figure 125: Upper Inside Cam Pin Removal; Figure 126: Flat Belt End Measurement - Precor AMT Series Service Manual

Figure 125: Upper Inside Cam Pin Removal

Flat Belt Installation - Upper Arm Cam
11 Lay the replacement flat belt on a flat surface with the flat belt
segments facing up. Measure the distance in from the end of the flat
belt 10 inches. Using a straight edge and permanent marker draw a
line across the flat belt at 10 inches. Repeat this process for the
other end of the flat belt.

Figure 126: Flat Belt End Measurement

12 Place the inside flat belt on the cam so the length of the flat belt
is draped towards the back of the AMT. Make sure the smooth side of
the flat belt contacts the cam and the segmented side is facing up.
13 Install a replacement 1/4-20X1 screw and shim in one of the cam
clamp screw holes, do not fully tighten at this time.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 202