Figure 315: Gas Shock - Precor AMT Series Service Manual

Figure 315: Gas Shock

8 Using needle nosed pliers, pull the retaining clip off the lower gas
mounting stud and remove shock.
Incline Motor Removal
9 Remove the hitch pin from the Incline motor mounting pin.
10 Remove the Incline motor mounting pin. If the Incline is jammed or
has excessive pressure on the pin,
pin out of the Incline motor tube and Incline platform using a punch
and rubber mallet.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
it may be necessary to drive the
Page 358