Replacing The Gas Shock; Figure 323: H-Brake Belt Tension Gauge - Precor AMT Series Service Manual

Figure 323: H-Brake Belt Tension Gauge

17 The belt gauge should read approximately 110 lbs. If the belt
tension is significantly high or low the belt tension may be
adjusted by loosening or tightening the H-Brake adjustment bolt.
18 Replace the covers as described per procedure,
page 152).

Replacing the Gas Shock

Replacing the Gas Shock

1 Remove the covers per procedure,
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Cover Replacement
Cover Replacement
(on
(on page 152).
Page 365