Table of Contents
Advertisement
replacement flat belt, tape the end of the replacement belt to the old flat belt at
the cam side and then pull the new belt through the upper arm as the old belt
is removed.
If the belt has already been removed, you can use a fish tape or coat
hanger to pull the belt through the upper arm. Ensure the flat belt is
routed over the top of any hardware that may be crossing the inside of
the upper arm.
18 Grasp the loose end of the flat belt from the back end of the upper
arm and then pull the belt through the arm to remove.
Note: the flat belt must be routed over the strut in the front arm
assembly. Failure to route the flat belt over the strut will cause
severe damage to the flat belt. The Figure below illustrates the
correct flat belt routing.
Figure 145: Flat Belt Routing - Transparent View of Arm
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Time Saver Tip: When installing the
Page 218
Advertisement
Table of Contents
Troubleshooting
