Important Safety Instructions When using the self-powered EFX , always take basic • Maintain the EFX in good working condition. Refer to the ® precautions, including the following: Maintenance section. Make sure that all fasteners are secure. • Read all instructions before using the EFX. These instructions •...
If you plan to dispose of your unit, contact Precor Commercial interference to radio communications. Products Customer Support for information regarding battery removal.
Canadian Department of European Applications Communications This product conforms to the requirements of the European Council Directive 89/336/EEC, Electromagnetic Compatibility This digital apparatus does not exceed the Class A limits for radio and has been tested to the following standards: noise emissions from digital apparatus set out in the Radio EN55022, Limits &...
For information about product operation or service, see the Precor website at www.precor.com. Should you need more information regarding customer support numbers or a list of Precor authorized service centers, visit the Serial number label Precor website at www.precor.com/contact.
Troubleshooting Error Codes ............17 Troubleshooting Heart Rate ............17 Self-Powered Features ............6 Informational Displays Prior to Shutdown ......... 6 Precor Commercial Equipment Limited Warranty..............18 Symptoms of a Low Battery ............7 Using the Optional Power Adapter ..........7 Replacing the Battery ..............8 Club Features ................9...
Self-Powered Features The power source for the EFX is the user. When a person pedals Note: If the EFX is connected to a CSAFE master device, a slightly above 40 strides per minute (spm), the power that is generated different scenario occurs. When ten seconds remain before the EFX allows the EFX to function properly.
EFX initiating shutdown procedures. When the pause time limit expires and the user has not resumed pedaling, the display returns to the Precor banner. Refer to Setting a Pause Time Limit. Product Owner’s Manual: Self-Powered Features...
Replacing the Battery The EFX battery is built to last for a long time. However, if you feel that the battery may need replacing, check with an authorized service technician. Refer to Obtaining Service. CAUTION: The battery stored inside the EFX contains hazardous materials and must be disposed of according to Hazardous Waste Regulations.
• The club programming mode is accessed by pressing the RESET • Display the number of hours the EFX has been in use key at the Precor banner. The remaining key presses must occur quickly and without pause. Always start at the Precor banner.
STANDARD. The default factory setting is set to display U.S. steps: STANDARD. To change this setting, perform the following steps: 1. At the Precor banner, press the following keys in sequence and 3. At the SELECT UNITS prompt, use an arrow key to select a unit without pause: of measure (U.S.
60 seconds, the display and 20 minutes. automatically resets to the Precor banner if no pedaling occurs for one minute. Note: The automatic cool-down period is appended to the end of any time-based program, so adjust the time limit accordingly.
14. When you are ready, press ENTER to save the program and period also reduces the amount of lactic acid in muscle tissue. return to the Precor banner. 9. At the SET COOL DOWN TIME prompt, use an arrow key to Note: If you prefer to exit the program without saving changes to cycle through the available time limits.
5. Write the numbers below. You will need these numbers when you Viewing the Odometer call Customer Support with display-related questions. This 1. At the Precor banner, press the following keys in sequence and information will help rule out any software-related problems: without pause:...
Page 16
The hour meter at the time time the error occurred. the error was detected. 12. When you are ready, press ENTER to return to the Precor Diagram 5: Error log banner. 8. Copy the error code information to paper so you can provide it to Customer Support if needed.
User ID Entry with CSAFE Equipment The EFX is fully compatible with CSAFE protocols. When the unit is connected to a CSAFE master device and the user maintains a stride rate above 40 strides per minute (spm), the user is prompted for a user ID.
EFX needs service. the ramp and roller wheels by taking the following steps. To order parts or to contact a Precor authorized service provider in 1. Remove the ramp cover.
A chest strap may provide better results. readings. Important: A heart rate can only be detected when the Precor heart rate receiver is properly installed in the display and the user maintains a minimum 40 spm. A user must also wear the chest strap or grasp both touch-sensitive handrail grips.
Conditions and Restrictions. period only. To claim under this warranty, the buyer must notify Precor or your authorized Precor dealer within 30 days after the date of discovery of any...
Page 21
LIABILITY, WHETHER ARISING IN CONTRACT (INCLUDING WARRANTY), 3. Repairs performed on Precor equipment missing a serial number or with a serial TORT (INCLUDING ACTIVE, PASSIVE, OR IMPUTED NEGLIGENCE AND tag that has been altered or defaced.
Page 24
Please detach and mail in the warranty registration within ten days of purchase.
Page 26
Any party contemplating the use of Precor’s product designs is hereby forewarned that Precor considers the P.O. Box 7202 Registration Card# 45622-101, en unauthorized appropriation of its proprietary rights to be a very serious matter. Precor will vigorously pursue all Woodinville, WA USA 98072-4002 unauthorized appropriation of its proprietary rights.