Replacing A Upper Arm Flat Belt Pulley; Upper Arm Flat Belt Pulley Replacement Procedure; Figure 100: Flat Belt Terminal Covers - Precor AMT Series Service Manual

Rear Flat Belt Terminal Cover Installation
1 Align the top of the replacement inside cover so that it is pointing
toward the floor. Place the bottom of the cover in between the flat
belt terminal and the stairarm pedal. Rotate the top of the cover up
and in to place.
2 Fasten the outside and inside terminal cover to the flat belt
terminal using the two #10-24 X 1.25 screws.

Figure 100: Flat Belt Terminal Covers

Replacing a Upper Arm Flat Belt Pulley

Upper Arm Flat Belt Pulley Replacement Procedure

1 Remove the main body covers as per procedure,
page 152).
2 Remove the tension from the inner flat belt pulleys by lifting up on
the stairarms, pulling the flat belts off the flat belt pulleys, and
then gently setting the stairarm down.
Upper Arm Cover Removal
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Cover Replacement
(on
Page 179