P80 System Test Table - Precor AMT Series Service Manual

P80 System Test Table

Systems Tests
Test
Auto Stop Test
Belt Speed Test
Incline Test
AMT Stride
Position Test
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Equipment Description
1 Touch Auto Stop Test, then Touch START.
2 The Auto stop test will start the belt
at 1 mph; count will be reset to 0, and
TRM Only
then count up with each step.
3 Touch STOP to end the test. Touch 
BACK to exit to Systems Test.
1 Touch Belt Speed Test, then Touch START.
2 The belt will start a 0.5 mph, using the
machine control paddle to increase by
0.1 mph increments. The console will
TRM Only
display motor current as the belt speed
increases or decreases.
3 Touch STOP to end the test. Touch 
BACK to exit to Systems Test.
1 Touch Incline Test, and then Touch
START.
2 Use the machine control paddle to change
the lift. The console will display the
analog to digital (A/D) incline position
TRM Only
number and the incline position in
percent of incline.
3 Touch STOP to end the test. Touch 
BACK to exit to Systems Test.
1 Touch AMT Stride Position Test and then
Touch START.
2 The High, Low and Dynamic positions will
be displayed. The low position display
shows the lowest position reading
achieved during the test. The high
position display shows the highest
position reading achieved during the
AMT Only
test. The dynamic position display
changes with current stride position.
Stride on the AMT to the maximum
horizontal movement in both directions.
At maximum stride length the low stride
display should read 0 and the high
stride display should read 40.
Page 64