Replacing The Lower Pca And Battery Bracket; Procedure; Figure 208: Lower Pca - Precor AMT Series Service Manual

Figure 208: Lower PCA

Replacing the Lower PCA and Battery Bracket

Procedure

1 Remove the main body covers as per procedure,
page 152).
2 Remove the lower PCA cover as per procedure,
"Removing the Lower PCA
3 Disconnect the data cable, incline motor cab le (Open Stride only),
generator cable, load cable, stride dial cable, battery cables, and
vertical sensor cable from the lower PCA
4 Remove the lower PCA as per procedure,
Lower PCA" on page 269).
5 Remove the #10-24X.75 screw located at the bottom left corner that
secures the bracket to the frame.
6 Carefully disengage wires form the securing clips on the lower PCA
battery bracket.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Cover" on page 268).
Cover Replacement
Lower PCA Cover
Lower PCA "Removing the
(see
(on
(see
Page 270