Replacing The H-Brake Drum Assembly; Procedure; Figure 313: H-Brake Belt Tension Gauge - Precor AMT Series Service Manual

Figure 313: H-Brake Belt Tension Gauge

20 The belt gauge should read approximately 110 lbs. If the belt
tension is significantly high or low the belt tension may be
adjusted by loosening or tightening the H-Brake adjustment bolt.
21 Replace the covers as described per procedure,
page 152).

Replacing the H-Brake Drum Assembly

Procedure

1 Remove the covers as described per procedure
page 152).
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Cover Replacement
,Cover Replacement
(on
(on
Page 356