20 Lift the stairarms and then thread the flat belts over the flat belt
pulleys.
21 Select the QUICKSTART program
resistance level 10 is displayed. Pedal the AMT for approximately
one minute, then recheck the belt tension.
Figure 216: Generator
22 The drive input belt tension should read approximately 135 ±5 lbs
and the generator belt tension should read approximately 85 ±5 lbs.
Drive Belt Gauge Instructions
See
23 Lift the stairarms and then thread the flat belts over the flat belt
pulleys.
24 Replace the covers as per procedure,
Replacing the Generator
Procedure
1 Remove the covers as per procedure,
2 Remove the lower PCA cover as per procedure,
"Removing the Lower PCA
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
and adjust the resistance key until
(on page 142)
Cover Replacement
Cover Replacement
Cover" on page 268).
(on page 152).
(on page 152).
Lower PCA Cover
(see
Page 278