Figure 123: Upper Arm Cam Covers; Figure 124: Upper Inside Cam Screw Removal - Precor AMT Series Service Manual

Figure 123: Upper Arm Cam Covers

Flat Belt Removal - Upper Arm Cam
Note: Any time the flat belt terminal screws are removed from the flat belt
clamp or cams, the screws must be discarded and replaced with new
screws.
9 Remove and discard the two 1/4-20X1 flat belt cam clamp screws and
shims that secure the flat belt to the clamp.

Figure 124: Upper Inside Cam Screw Removal

10 Using a screw driver tip, push out the pin from the flat belt loop
and cam clamp and then slide the flat belt out of the cam clamp.
Remove the flat belt.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 201