Table of Contents
Advertisement
Figure 94: Belt Guard Interlocking Tabs and Slots
13 Grasp each belt guard mounting ring, lift the belt guard into
position over the upper arm mounting bolts, and then secure each
mounting ring to the connection ring.
14 Replace the upper arm covers as per procedure,
Replacement
Replacing a Flat Belt Terminal
Flat Belt Terminal Replacement Procedure
Rear Flat Belt Terminal Cover Removal
1 Remove the two #10-24 X 1.25 screws that secure the flat belt
terminal covers to the flat belt terminal, remove the outside
terminal cover.
2 Rotate the top of the inside terminal cover down until it is below
the stairarm pedal, pull to remove.
3 Repeat the process for the remaining rear flat belt terminal cover.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
(on page 161).
Upper Arm Cover
Page 175
Advertisement
Table of Contents
Troubleshooting
