Displaying P30 Information; Procedure - Precor AMT Series Service Manual

Press the
PAUSE/RESET
key to exit the
Hardware
Validation tests.

Displaying P30 Information

The information display will access the following data:
♦ Odometer
♦ Hour Meter
♦ U-Boot Software
♦ U-Base Software
♦ Lower Software
♦ Metrics Board Software
♦ Stride Dial Software
♦ Serial Number
♦ Usage log
♦ Error Log

Procedure

1 The AMT 885, 835, 833, and 832 uses the standard access codes to
provide access to the various software features. Use the PAUSE key
and the numeric keypad to enter the access code. The standard access
codes use all sequential key presses. The allowable delay between
key presses are short. . If too much time is taken between
key
presses or the wrong key is pressed the access procedure will be
aborted. If the access is aborted, it will be necessary to start
over from the beginning.
2 See, P30 Information Table
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
"P30 Information
(see
Table" on page 20).
Page 19