Figure 226: Dive Input Belt - Precor AMT Series Service Manual

Figure 226: Dive Input Belt

12 The belt gauge should read approximately 135 ±5 lbs. If the belt
tension is significantly high or low the belt tension may be
adjusted by following the steps below. See
(on page 142)
13 Loosen or tighten the step up pulley adjustment bolt until the belt
gauge reads approximately 140 lbs. See
page 142)
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Drive Belt Gauge Instructions
Drive Belt Gauge Instructions
(on
Page 288