Precor AMT Series Service Manual page 18

Press the  key
Press the OK key
SPM/ RPM
(Strides/
Revolutions
Per Minute
Press the CLEAR
Non-
key to return to
Treadmills
Hardware
only)
Validation
Press the OK key
Incline/
Crossramp
Press the CLEAR
key to return to
Machine Test
Press the  key
Press the OK key
Battery Test Press the CLEAR
key to return to
(Non-
Hardware
Treadmills)
Validation
Press the CLEAR
key to return to
Hardware
Validation
Press the  key
Stride Position
Test
Press the OK key
AMT12 (Open
Press the CLEAR
Stride Only)
key to return to
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
RPM will be displayed.
The console will display the Pulse. The pulse is
showing a count of zero crossings from the
generator. RPM shows a software averaged version
of pulse.
Use , keys to view the following RPM readings.
PULSE
MIN
MAX
Two numbers will be displayed, the percent of lift and
A/D number related to the current lift position. The
A/D (analog to digital) number represents the lift
potentiometer reading. The A/ D number will be in
the range of 0 to 255 or 0 to 32769.
The lift may be operated using the
INCLINE/CROSSRAMP keys. The incline
percentage and A/D numbers will change
accordingly. Care must be taken while operating the
lift in this mode because the normal upper and lower
range limits are not in effect. It is possible to operate
the lift to its physical limits and may cause the lift
motor to jam.
BATTERY will scroll across the display.
The console will display the battery test. Battery test
will display battery voltage.
STRIDE POSITION TEST will scroll across the
display.
The low, high and actual stride positions will be
displayed. The low display shows the lowest position
reading achieved during the test. The high display
shows the highest position reading achieved during
the test. The actual display changes with the current
stride position. Stride on the AMT to the maximum
Page 16