Possible Remedies - Precor AMT Series Service Manual

Possible Remedies

6 Inspect power cord from wall plate to power supply (if non-
Treadmill) or patch panel (if Treadmill).
are tight and that there is no damage.
if appropriate.
panel (if non-Treadmill).
needed.
7 Open the machine and inspect the power cord running from patch panel
to console (if non-Treadmill) or from patch panel to power supply
(if Treadmill).
Treads, also check from power supply to console.
known good to test.
8 Inspect power supply for damage.
to test. Replace, if needed.
9 Ensure that facility has configured their power correctly.
non treadmill units can be connected through one dedicated circuit.
Each treadmill must be on a dedicated, branch circuit.
Hot Leads must not be shared among treadmills.
supplied to the machines is not up to specification, the customer
will need to contact an electrician to make the needed repairs.
10 If the power, power supply, and power cabling are all good and
securely connected, the console will need to be replaced.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Inspect connections from power supply to patch
Reconnect or replace all cables as
Swap with known good to test, if needed.
Verify all connections
Swap with known good cable,
Swap with known good power supply
If the power
On
Again, swap with
About 8
Neutrals and
Page 124