Figure 147: Upper Outside Cam Pin - Precor AMT Series Service Manual

22 Loop the end of the flat belt to the 10 inch mark. While holding the
flat belt end on the 10 mark, work the loop into the cam clamp. A
1/2 inch deep set socket can be used to assist in pushing the belt
into place. When the flat belt loop is about half way into the cam
clamp, push the pin into the flat belt loop.
23 Continue to work the flat belt loop and pin into the cam clamp until
the side of the flat belt is resting next to the clamp screw.

Figure 147: Upper Outside Cam Pin

24 Install the second 1/4-20X1 replacement screw and shim that secures
the flat belt to the cam. Do not tighten fully at this time.
Flat Belt Pulley Installation
25 Slide the pulley shaft into the flat belt pulley and place one
spacer on each side of the flat belt pulley. Ensure the belt goes
over the top of the pulley. Insert the assembly into the upper arm.
26 Secure the flat belt pulley assembly to the
mounting bolt, washers and lock nut. Thread the mounting bolt from
the inside of the upper arm towards the outside of the upper arm,
torque to 300 inch pounds (25 ft-lbs) or 25 foot pounds.
Note: The lock nut should be on the outside of the upper arm.
Flat Belt Installation - Rear Terminal
27 Install a replacement 1/4-20X1 screw and a shim in one of the clamp
screw holes; do not fully tighten at this time.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
upper arm using the
Page 220