Precor AMT Series Service Manual page 23

Press the OK key.
Odometer
Press the CLEAR key to
exit the odometer display.
Use the , keys to move
to move to HOUR METER.
Press the OK key.
Hour Meter
Press the CLEAR key to
exit the HOUR METER
display.
Use the , keys to move
to move to U-BOOT SW.
Press the OK key.
U-Boot SW
Press the CLEAR key to
exit the U-BOOT SW
display.
Use the , keys to move
to move to HOUR METER.
U-Base SW Press the OK key.
Press the CLEAR key to
exit the U-BASE SW
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
The odometer will display HORIZONTAL distance
in miles or KM depending on Club parameter
settings and VERTICAL distance in steps.
Note: The odometer data is
stored in non-volatile memory
on the upper PCA. If the upper
PCA is replaced the odometer
data will be lost.
The operating time of the unit will be displayed as
12345 HOURS. The operating time is defined as
total amount of time that the unit has operated in
program modes. The hour meter is also used to
provide the time stamp for the error code log.
The software part number will be displayed as
XXXXX-XXX.
The software part number will be displayed as
XXXXX-XXX.
Page 21