Function Of "P-Analog Outputs; Operation Of Several Inverters On One Pc - Siemens SINAMICS G180 Installation And Operating Instructions Manual

Operation
8.1 Operation
8.1.13

Function of "P-ANALOG OUTPUTS"

The inverter has two electrically isolated analog outputs. Depending on the type of connected
measuring instrument, the output signal is automatically set to a +20 mA current source or to
a +10 V voltage source. Input the following in the "P-ANALOG OUTPUTS" menu:
● Which signals should be output?
● What is the full scale value of your display instrument?
● Should a 4 mA addition or a different value be added?
● Should a center point increase be output for the presentation of bipolar signals?
8.1.14

Operation of several inverters on one PC

It is possible to actuate several inverters simultaneously with one PC using the PC tool "IMS".
You can select the communication interfaces Ethernet, Profibus, Modbus or RS 485 . In all
cases, you need a converter for the relevant network RS 485, Modbus or Profibus on the PC
with the PC tool "IMS".
If you create the network using Profibus or Modbus, you will also need the option "Profibus"
or "Modbus", as described in the corresponding sections.
Further information about the operation of several inverters on one PC can be found in the PC
tool "IMS". A communication network based on RS 485 limits the network to a further 63 nodes.
86
Installation and operating instructions Sinamics G180
Operating Instructions, 05/2013, 4BS0751-001