Installing The Etu In The Electra Elite Ipk Ii Ksu - NEC Electra Elite IPK II Installation And Maintenance Manual

Document Revision 2
___________________________________________________________________________________
2.2
To install the ETU:
1.
2.
___________________________________________________________________________________
D - 2

Installing the ETU in the Electra Elite IPK II KSU

When the IAD(8)-U( ) ETU is used for the H.323 Trunk card application, this
ETU is assigned in the KSU as an ETU. This ETU has eight ports, and
installed in slots S1~S8 of the KSU.
Insert the IAD(8)-U( ) ETU in to any slot in the KSU. Make sure that all the
switches in S2 are set to the ON position (factory default).
Once the LEDs CH 8(D1) and CH7(D3) are lit SOLID and the Status LED (D12)
is flashing red, connect your cross over cable or hub to Ethernet connector (J6)
on the IAD(8)-U( ) ETU. The IAD(8)-U( ) is ready to install your IP Application
package.
Figure D-1 IAD (8)-U( ) ETU
Electra Elite IPK II IAD(8)-U( ) ETU Installation
H.323 Trunk