Figure 9-175 Installing The Ip Video Doorphone Using Wall Mount Bracket Set - NEC Univerge SV9100 System Hardware Manual

9-178
5. Mount the Screw Cover.
TIP
16.5.4 Installing the IP Video Doorphone Using a Wall Mount Bracket
(IP3WW-CDH BRACKET SET)
This section describes how to install the IP Video Doorphone using a Wall
Mount Bracket.

Figure 9-175 Installing the IP Video Doorphone Using Wall Mount Bracket Set

1. Loosen the Main Body fixed screw and remove the Main Body from
the Mounting Bracket.
2. The Rear Cover is mounted to the Wall Mounting Plate (on the wall)
using two wood screws (3.8x20mm) or M4x25mm screws.
3. Insert the Bracket tab into the top of the Rear Cover.
4. Secure the Main Body and Rear Cover with the retaining screw.
5. Mount the Screw Cover.
When there is a gap between the Wall Mounting Plate
(on the wall) and the Bracket, the Bracket may be
warped due to an over-tightened screw. Simply loosen
the screw.
Installing SV9100 Optional Equipment
Issue 3.0