Figure 5-113 Attach Wm-L Unit To Wall Plate; Figure 5-114 Plugging In Line Cord - NEC Univerge SV9100 System Hardware Manual

5-98
5.2.13.2 Mount Multiline Terminal on Wall Plate using WM-L
UNIT
1. Locate the screw holes on the base and hang the cover over
the screws on the wall plate as illustrated in
Attach WM-L UNIT to Wall

2. Plug one end of the line cord into the wall receptacle. Leave
about eight inches of cord and bundle the rest.
3. Plug the opposite end of the line cord into the multiline
terminal as illustrated in

Figure 5-114 Plugging in Line Cord

Installing DT Series Digital and IP Multiline Terminals
Plate.

Figure 5-113 Attach WM-L UNIT to Wall Plate

Because of variation in wall plates, this method is not
recommended.
Figure 5-114 Plugging in Line
Issue 3.0
Figure 5-113
Cord.