NEC Univerge SV9100 System Hardware Manual page 497

Issue 3.0
3.2
SV9100 System Hardware Manual
3.1.4 Registering to a Different Base
After the repeater is registered, you must reset it before you can change the
registration to a different base. If you want to reset the repeater and clear its
registration, follow the steps below:
1. Disconnect the power.
2. Connect the power for one to five seconds, and disconnect it again.
3. Connect the power for 25~35 seconds.
4. Disconnect the power, and perform the registration procedure with
the new base.
Installing the Repeater
3.2.1 Finding the Right Location
To get the best operating conditions for the repeater, it is important to place
it correctly. Here are a few tips for placing repeaters:
Place the repeater as high as possible, but at least six feet above

the floor.
Make sure you have good reception from the base.

Make sure the location is close to a standard 120 V AC power outlet.

Never install electrical cords across a traffic area: they can create a
trip hazard or become damaged and create a fire or electrical hazard.
Allow at least 30 feet between repeaters (if you are installing

repeaters across multiple floors, remember to allow 30 feet vertically,
also).
Avoid sources of electrical interference, such as hi-fi systems, office

equipment or microwave ovens.
Avoid heat sources and direct sunlight.

Avoid things that can interfere with radio signals, such as metal

doors, thick walls, niches and cupboards.
6-19