Table 5-15 Ten Key Kit Type - NEC Univerge SV9100 System Hardware Manual

5-76
5.2.4.2 Configuring the Digital Telephone for the Correct
Number of Line Keys
1. With the telephone not plugged in and the handset on-hook,
press the 4 and 6 buttons on the numbered keypad and
connect the telephone cable.

2. Press 1 to enter the Line Key Type mode.

3. Follow the directions below for the type of line key module
installed:
Table 5-14 Line Key Type
Line Key Type
2-Button
6-Button
8-Button
12-Button
24-Button
4. Save to memory by pressing line key 2, 8, 14 or 20. The
display changes back to the Service Class R/W mode and
the Message Waiting (MW) LED is On Red.
5. Press Exit to return the telephone to idle.
5.2.4.3 Configuring the IP Telephone for the Correct Number of
Line Keys
1. Press Menu, then 0 (Config) to enter the terminal program
mode.
2. At the Login screen, enter the user name (default = ADMIN)
and password (default = 6633222) and press the OK
Softkey.
3. Press 3 for Maintenance Setting.
4. Press 4 for Adjust.
5. Press 2 for Key Kit Type.
6. Press the Up/Down key to select the Key Kit.

Table 5-15 Ten Key Kit Type

Ten Key Kit Entry
Kit1
Kit2
Installing DT Series Digital and IP Multiline Terminals
This places the telephone into Service Class Read/
Write (R/W) mode. The Message Waiting (MW) LED
should be On.
The Message Waiting LED should flash.
Description
Type A – Japan with cursor key
Type A – US with cursor key
Issue 3.0
Push
1
2
3
4
5