NEC Univerge SV9100 System Hardware Manual page 633

Issue 3.0
SV9100 System Hardware Manual
12.2.6 Installation
CAUTION
12.2.6.1 Location Preparation
The wiring for the extensions should be within six feet of the PC
location. For this reason, the PC for the NEC BackOffice
Recorder should be located near the MDF for extension wiring.
The installer must prepare the wiring to tap off the digital pair
with a T-Connect type setup.
It may be desirable to fasten the devices to a PC or rack. Since
the devices are lightweight, this can be done quite easily with
Velcro tape.
12.2.6.2 Set Up PC
WARNING
1.
2.
3.
4.
5.
6.
DO NOT install the NEC BackOffice Software until instructed!
It is critical that you follow the steps in the installation procedure
in the order listed below. Failure to do so results in an
unsuccessful installation.
DO NOT connect more than four of the 4-Port
Digital Call Logging Unit devices to each USB
Controller Card.
Set up the PC with the appropriate number of USB
Controller Cards and/or USB hubs. Follow the installation
instructions for the Controller Card carefully. The PC should
be connected to the LAN for supervisor access and to
facilitate Windows and software updates as needed. It may
be desirable also to load PC Anywhere on the PC for remote
administration of the application.
After USB cards are installed, go to
www.windowsupdate.com. Download and install any
updated device driver that may be available for Windows XP
or Windows 7 and your USB Controller Cards. If your card
came with a driver CD this step may have been taken care
of during installation of the card.
Update to the most up to date Service Pack; this is available
as a free upgrade from the Windows update web site.
When all USB Controller Cards are installed and the PC
updated, restart the PC.
Connect any USB hubs if applicable.
The brand or type of USB hub must match
that of the USB Controller Card.
IMPORTANT
After USB hubs are installed, restart the PC again.
9-77