NEC Univerge SV9100 System Hardware Manual page 260

4-10
2.6.2 Performing a Hot Start
The section describes how to load system software from flash memory and
customer data from RAM memory.
CAUTION
1. Turn the system power off.
2. After it has powered down, press the button again to power the
system back up. Wait approximately two minutes.
3. When the system has completed reloading the software, the Status
LED is flashing on the GCD-CP10.
2.6.3 Resetting the System
This section describes resetting a system that is running. Observe the
important information listed below.
To reset the system:
2.6.3.1 Initial Programming
The system can be programmed using three methods:



To program using a multiline terminal, enter programming
mode:
1.
2.
3.
4.
5.
IMPORTANT CONSIDERATIONS
System software is loaded from flash memory, and customer
data is from RAM memory.
Programming using a multiline terminal
PC Programming
Web Programming
Go to any working display telephone.
Do not lift the handset.
In a newly installed system, use extension (port 1).

Press Speaker.
<Bold># <Bold># .
 
Password
Dial the system password + Transfer.
Issue 3.0
Installing the SV9100 Blades