Figure 4-9 Iple Daughter Board - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Figure 4-9 IPLE Daughter Board

SV9100 System Hardware Manual

GPZ-IPLE (Voice over IP Daughter Board)

The current GPZ-IPLE daughter board requires a single DSP IP address.

The IPLE daughter board provides:

256 (GPZ-IPLE) channels

Refer to the following tables for maximum upgrade capacities of the

GPZ-IPLE daughter board:

Table 2-6 SV9100 Maximum 9.5" Gateway and 19" System

Capacities – Blades on page 2-12

Table 2-7 SV9100 Maximum 9.5" Base and Expansion System

Capacities – Blades on page 2-14

When installing an IPLE daughter board, the system allocates the maximum

number of trunk ports for the blade being installed.

The IPLE does not have any DSP limitations based on CODEC settings.

With SV9100 software and GPZ-IPLE daughter board

installed, half-duplex connections are not supported.

For troubleshooting purposes, a managed switch capable of

port mirroring is required to capture packet data from the

SV9100 IPLE Ethernet port.

Table of Contents