Figure 9-104 Ada-L Unit; Table 9-3 Ada-L Unit Switch Settings; Table 9-4 Dt330 Compatibility Settings - NEC Univerge SV9100 System Hardware Manual

Table 9-4 DT330 Compatibility Settings

ADA-L Unit Switch
Settings
ADA Connection for
Recording Only.
ADA Connection for
Sending Recorded Calls
to the Telephone.
To Send and Receive to
the Terminal
Lot Numbers: I, J – Hardware Revision
Lot Numbers: L, M, S – Software Revision
To verify DT-330 terminal firmware, hold down keypad buttons 1, 2 and 3 while plugging the line cord into the

terminal.
9-124
To provide control to the recorder or to enable/disable the record start warning
tones, refer to Table 9-3 ADA-L UNIT Switch

Table 9-3 ADA-L UNIT Switch Settings

Switch
Dip DSW 1
Switches
(DSW)
DSW 2
and
DSW 3
DSW 4
DSW 5
DSW 6
DSW 7
and
DSW 8
Do not connect T1 and T2 when DSW switches 3 and 4 are On.

xxx I Lx or lower
(Version 1.E0 or lower)
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 2, 3, 5, 7 and
8 are OFF. Switches 1, 4
and 6 are ON.
Not supported
Settings.
Description/Settings
Record Confirmation Tone
On = Tone On (Default)
Off = Tone Off
Connection for the Record Confirmation Tone Source
On = Connect
Off = No Connection (Default)
Output the Hook Signal to External Recording Device
(Requires cable from T1/T2)
On = Output (Default)
Off = No Output
Termination Impedance for OUT Jack
On = 30ohms (Recording level is lower)
Off = 600ohms (Recording level is higher) (Default = Off)
Upgrade F/W Version (Not normally used)
On = (Default)
Not Used
Off = (Default)
Terminal Lot Number DT-330
xxx I Mx
(Version 8.10)
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 2, 3, 5, 7 and
8 are OFF. Switches 1, 4
and 6 are ON.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Installing SV9100 Optional Equipment
Issue 3.0
xxxJSx or higher
(Version 2.20 or higher)
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches 4
and 6 are ON.
Dip switches 2, 3, 5, 7 and
8 are OFF. Switches 1, 4
and 6 are ON.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches 4
and 6 are ON.