NEC Univerge SV9100 System Hardware Manual page 352

4-102
Multimedia Conference Application

The VoIPDB is required for IP telephones to communicate with non-VoIP
UNIVERGE SV9100 telephones, and to place or receive outside calls, must
be connected to either an external switching hub or to the Router blade.
The
GCD-RGA blade pl
any port unless the conference application is licensed. Each blade
provides four RJ-45 port connectors for LAN terminals. Depending
on the type of LAN terminal, the blade may not detect the difference
between straight cable and crossover cable automatically. If
auto-crossover is not functioning, use straight cable for that terminal
connection.
6.4.2 Installation
Only one GCD-RGA can be installed per system.
IMPORTANT
1. Install CompactFlash on GCD-RGA.
2. In SV9100 Program 10-54-01, assign the appropriate number of RGA
Conference license 6300 to the universal slot the GCD-RGA blade is
installed in.
3. Plug the GCD-RGA blade into any universal slot.
4. Refer to the UNIVERGE SV9100 RGA Multimedia Conference
Solution Installation and Configuration Guide for additional
programming.
6.4.3 Switch Settings
The Reset Switch allows the technician to:
Initialize Factory Defaults: Hold the reset button (PB) for five seconds

during a power-on of the GCD-RGA.
Reset the GCD-RGA: While GCD-RGA is running hold the reset

button for more than 1 second.
Upgrade: With the GCD-RGA unseated insert a USB memory device

in the USB Interface. Then hold the reset button and insert the
GCD-RGA into the system. The USB will be checked for a valid SW
package. If a compatible SW package is found, the CPU will copy it
from the USB memory device. If the USB memory device does not
contain a valid SW package, the GCD-RGA will boot normally.
ugs into a universal slot and does not consume
Do not plug the RGA LAN into a customer's existing network
without first verifying the RGA's DHCP server will not cause
a conflict. If needed, connect the support PC directly to the
RGA to make configuration changes before connecting the
existing network.
Issue 3.0
Installing the SV9100 Blades